The PC6-01 is a compact straight push-in fitting that connects 6 mm outside-diameter tube to an R1/8 BSPT tapered female port. Its brass hex body is easy to tighten, while the blue release collar makes tube changes quick.
Specifications
ModelPC6-01
Tube connection6 mm OD push-in
ThreadR1/8 BSPT tapered male
Connector formStraight
Working pressure0 to 1.0 MPa
Working temperature-5 to 60 degrees C
Body materialBrass
Seal materialNitrile rubber
Spanner size12 mm
Datasheets
What's in the box
1 x PC6-01 pneumatic fitting
Great for
Pneumatic air lines
Automation and prototyping
6 mm tube systems
Custom Bowden setups with a matching R1/8 port
Wiring & getting started
- Depressurise the system and confirm that the port is R1/8 BSPT and the tube is 6 mm OD.
- Tighten the fitting using the 12 mm hex. Do not tighten by turning the release collar.
- Cut the tube square and make sure the outside surface is clean and undamaged.
- Push the tube fully into the fitting, then pull it gently to confirm it is locked.
- To remove the tube, keep the system depressurised, press the blue collar evenly and pull the tube straight out.
Note: This fitting has an R1/8 BSPT tapered male thread, not an M10 thread. Tube is sold separately.