Solid core hook-up wire is the stiff, single-strand wire used for breadboard jumpers and tidy point-to-point wiring. This is 22 AWG, the size that pushes straight into a breadboard or an Arduino header socket and stays there, in a 10 m coil you cut to length.
Use it to make breadboard jumpers the exact length you need, to wire stripboard and perfboard, or to run links inside a project box. It holds the shape you bend it into, so it suits wiring that stays still. A lead that flexes in use, such as one running to a hinged lid or a moving motor, needs stranded wire instead, like our 26 AWG hook-up wire. Choose black, red, white, yellow or blue.
Specifications
Wiring & getting started
- Cut and strip
Cut the length you need and strip 6 to 8 mm from each end for a breadboard. Use the 22 AWG (0.6 mm) notch on your wire strippers. A nick in a solid conductor is where it snaps later, so if you score the metal, cut the end off and strip it again.
- Push it in
Push the bare end straight down into the breadboard hole, then bend the wire flat to the board for a tidy layout. When an end gets kinked after a few uses, snip it off and strip a fresh one instead of forcing it in.
- Soldering
The conductor is tinned, so solder takes to it easily. PVC insulation softens and pulls back from the joint if the iron stays on too long, so make each joint in two or three seconds.
Note: This wire is for low-voltage electronics, such as 5V, 12V and 24V projects. Do not use it for mains or fixed house wiring.
