This is a closed black case for one 9V (PP3) battery, with an on/off slide switch on the base and red and black wire leads. The battery presses straight onto two snap studs built into the end of the case, so there is no separate snap clip to work loose, and the lid slides shut over it. You can switch a project off without pulling a wire or taking the battery out. Battery not included.
It suits guitar pedals, alarms, LED and buzzer circuits, sensors, small boards and test gear: anything that draws tens of milliamps. The leads end in bare tinned wire with no plug, so they clamp straight into screw terminals, such as our DC barrel jack screw terminal adapter, or you solder them to a board, header pins or Dupont jumper wires for a breadboard.
Specifications
Datasheets
Wiring & getting started
- Connect the leads first
Red is positive and black is negative. Join each lead to your circuit before the battery goes in. The tinned ends clamp straight into screw terminals. For a breadboard, solder each end to a male header pin or a cut Dupont jumper wire so it plugs in, as bare stranded wire is too soft to push into the holes. Or solder the ends to your board. Tape the leads down so a tug pulls on the tape, not on the thin wire where it leaves the case.
- Fit the battery
Slide the switch to OFF. Slide the lid off, then press the battery onto the two studs at the end of the case. The battery's terminals are different sizes, so it only fits one way round. Lay it flat and slide the lid back on until it clips shut. If the project gets knocked about, put a small screw through the hole at the lead end to stop the lid sliding off.
- Switch on and check
Slide the switch to ON. A multimeter across the two leads should read about 9V with a fresh alkaline battery. No reading means the switch is still off or the battery is not fully pressed onto the studs.
- Switch off when you finish
A 9V battery suits circuits that draw tens of milliamps. Switch off between uses so the circuit does not flatten it.
Note: Keep the two bare lead ends apart while the battery is in and the switch is on. A short across them heats the thin wires and the battery quickly.
