A dual-sided spring steel build plate purpose-built for the Voron V0 — textured PEI on one side for strong first-layer adhesion, smooth PEI on the other for a clean print underside. Magnetic base included: peel, stick, and snap the plate on to print. Flex the sheet to pop prints off cleanly, no scraping required.
Specifications
| Dimensions | 120 × 120mm |
| Surface Side A | Textured PEI — enhanced first-layer grip |
| Surface Side B | Smooth PEI — clean print underside finish |
| Max Operating Temperature | 300°C |
| Mounting | Magnetic base (included) |
| Compatible Filaments | PLA, PLA+, PETG, ABS, TPU |
What's Included
| 1 × | 120×120mm Spring Steel Build Plate (dual-sided PEI) |
| 1 × | Magnetic base sheet |
Installation:
1. Peel the backing paper from the magnetic base and press it firmly onto your printer's heated bed.
2. Place the spring steel sheet onto the magnetic base — it will snap into place.
3. Peel the protective film from the PEI surface before your first print.
To remove prints, simply flex the spring steel sheet — most prints pop off without any tools.
1. Peel the backing paper from the magnetic base and press it firmly onto your printer's heated bed.
2. Place the spring steel sheet onto the magnetic base — it will snap into place.
3. Peel the protective film from the PEI surface before your first print.
To remove prints, simply flex the spring steel sheet — most prints pop off without any tools.
Common Questions
Which side should I print on?
Use the textured PEI side for most prints — the rougher surface improves first-layer adhesion, especially for PLA and PETG. Use the smooth PEI side when you want a smooth finish on the bottom of your print. Both sides work with the same range of filaments.
How do I care for the PEI surface?
Clean the surface with IPA (isopropyl alcohol) before each print to remove skin oils and residue. Avoid touching the surface with bare hands. If adhesion degrades over time, a thorough clean with IPA or a light scuff with fine sandpaper will restore it.
Please note: Only 1 in stock. Designed specifically for the Voron V0 120×120mm print bed. Peel the protective film from the PEI surface before first use.