Stranded hook-up wire is made of many fine strands, so it bends and flexes without snapping. This is 24 AWG in a 10 m coil you cut to length, the right weight for leads inside a project box, wiring to screw terminals and solder joints, and cables that get moved.
Choose red, black, white, blue, green or yellow. For a breadboard, solid wire is the better fit because stranded ends splay and will not push in cleanly, so use our 22 AWG solid core wire for jumpers. For a shorter, finer coil see the 26 AWG 5 m wire.
Specifications
Wiring & getting started
- Cut and strip
Cut the length you need and strip 6 to 8 mm. Use the 24 AWG notch on your wire strippers so no strands are cut. Twist the strands together in one direction before you use the end.
- Terminals and connectors
Twist the end and put a little solder on it, or crimp on a ferrule, before it goes into a screw terminal, so no stray strands escape. Strip 11 mm for a WAGO 221 lever connector.
- Soldering
The strands are tinned, so solder takes easily. PVC insulation softens and pulls back from the joint if the iron stays on too long, so keep each joint to two or three seconds.
Note: This wire is for low-voltage electronics, such as 5V, 12V and 24V projects. Do not use it for mains or fixed house wiring.
