Reliable, ready-to-use momentary push button ideal for DIY electronics, automotive, arcade builds, and outdoor control panels. Pre-soldered with 12.5cm 20AWG leads — no soldering required, just connect and go.
- Momentary action — press for ON, release for OFF
- Pre-soldered 12.5cm 20AWG leads included
- IP65 waterproof — dust and water jet resistant
- Rated 3A @ 125VAC / 1A @ 250VAC / 5A @ 12VDC
- 12mm panel cutout
- SPST / 1NO contact configuration
- Every batch locally quality checked before dispatch
Installation at a Glance
Use a step drill or standard 12mm bit in your panel or enclosure.
Feed the pre-soldered leads through the hole, insert the button body, and tighten the locking nut from behind.
Connect the two 20AWG wires into your circuit — no polarity for momentary SPST. Red to signal/power, black to ground is conventional.
Verify actuation before sealing your enclosure. The IP65 seal is on the front face — ensure the nut is tightened fully for weatherproofing.
Specifications
What's Included
Pre-soldered with 12.5cm 20AWG leads. Ready to install into a 12mm panel cutout — no soldering required.
Common Uses
Common Questions
No — SPST momentary switches are not polarity sensitive. Either wire can go to your signal or ground. Red to positive and black to ground is conventional but not required.
Yes — the 20AWG leads can be extended by soldering and heat-shrinking additional wire. Keep extensions reasonable in length to avoid voltage drop in low-power signal circuits.
Yes — the IP65 rating means it is sealed against dust ingress and water jets. It is suitable for outdoor panels and enclosures exposed to rain or spray, but not for full submersion.