A small buzzer board that plays notes. It has no oscillator of its own, so your code supplies the pitch: tone() on an Arduino, PWM on an ESP32 or Pico. That makes it the one to pick for start-up jingles, simple tunes, rising alarms and different beeps for different events. A transistor on the board does the switching, so your pin only supplies a few milliamps.
Passive and active buzzers look alike, and the difference matters. A passive buzzer stays silent on a plain HIGH or LOW and only clicks, because it needs a switching signal. An active buzzer beeps by itself when you switch it on, with one fixed tone. If you only want a fixed beep from digitalWrite, get our Active Buzzer Module instead. This board is the Low level type: leave I/O HIGH when idle, and on a 3.3V board such as an ESP32 or Pico, power VCC from 3.3V, not 5V.
Specifications
Datasheets
Wiring & getting started
- Connect three wires
The pin names are printed beside the header. VCC goes to 5V, I/O to D8 and GND to GND. On an ESP32 or Pico, use 3.3V for VCC. Three female jumper wires push straight onto the pins.
- Load the test code
Upload this sketch to an Uno. It plays eight notes, then sets the pin back to HIGH, which is the quiet level for this board.
Example Arduino codeArduino C++
// Passive buzzer module test (MOD-BUZ-PAS-L, Low level trigger). // Module VCC to 5V, I/O to D8, GND to GND on the Uno. // The board is silent while the pin is HIGH, so HIGH is the idle level. const int BUZ = 8; const int NOTES[] = {262, 294, 330, 349, 392, 440, 494, 523}; // C4 up to C5 void playNote(int hz, int ms) { tone(BUZ, hz, ms); delay(ms + 20); digitalWrite(BUZ, HIGH); // tone() leaves the pin LOW, so put it back to idle } void setup() { digitalWrite(BUZ, HIGH); // set the idle level first pinMode(BUZ, OUTPUT); // so it stays quiet at start } void loop() { for (int i = 0; i < 8; i++) { playNote(NOTES[i], 300); } delay(2000); } - Check it works
You should hear a rising scale from C to C, then two seconds of quiet, repeating. If you only hear clicks, the code is switching the pin on and off with digitalWrite instead of calling tone(). Change the numbers in NOTES to play your own tune.

