A plug-in power supply for a solderless breadboard that runs from a USB cable or a DC plug pack. It sits across one end of an MB-102 style breadboard, pushes into both power rails and gives a steady 5V or 3.3V on each rail. A slide switch on each side sets that rail, so one side can run a 5V Arduino sensor while the other runs a 3.3V part such as an ESP32 module.
This white version has a mini USB input as well as the DC jack, and its notched shape leaves the breadboard rows under the middle of it free. It has no on/off switch, so it's on whenever it's plugged in. On USB power, plan on up to about 500mA across both rails: that's what a computer USB port gives, and the board's resettable fuse is sized for about the same. If you want an on/off button and a USB-A socket instead, the black MB102 module has both. The blue MB102 module has the same two inputs on a narrower board, with jumpers that can also switch a rail off.
Specifications
Datasheets
Wiring & getting started
- Line up + with the red line
Each end of the module has a + row and a - row of pins, marked on the board. Turn the module so both + rows sit over the red lines of the breadboard, then press it straight down. On our 830 point and 400 point breadboards that one direction gets both sides right. Turned the other way round, both rails come out reversed.
- Set each rail's switch
Slide the switch at each end to 3V3 or 5V, as marked beside it, before you plug in. A 3.3V part such as a BMP280 or an ESP32 module can be damaged on a 5V rail.
- Plug in one power source
Use a mini USB cable (the older, wider plug, not micro USB or USB-C) from a computer or phone charger, or a 7.5 to 9V plug pack with a 5.5 x 2.1mm centre-positive plug. The power light comes on straight away. Use one source at a time, never both.
- Measure before you connect
Check each rail with a multimeter: 4.9 to 5.1V and 3.2 to 3.4V are normal. A rail reading close to your plug pack voltage means its switch is caught between positions, so slide it fully across.
- Wire your circuit
Run jumper wires from the rails or the header pins to your parts. Give motors, servos and LED strips their own supply, because their start-up current is more than this module gives.
